Terms and Definitions


PLCC Installation TJ-85 Hot Air

PS-90 Handpiece
PS-90 Handpiece

1. Start with a heater temperature of 482°C (900°F) and adjust as necessary.

2. Install tip onto the Mini ThermoJet® Handpiece.

3. Apply a small bead of solder paste along the land pattern using a dispenser. (A)

4. Position component onto lands using a HandiPik® or tweezers. (B)

5. Starting at MINIMUM, adjust pressure output (on power supply) so hot air scorches a tissue from approximately 0.5cm (0.2”) away. (C)

6. Direct hot air over component with tip at a distance of 2.5cm (1.0”) to pre-dry solder paste.(D)

7. When pre-drying is observed (paste has dull, flat appearance), bring tip closer (0.5cm [0.2”]) and slowly move tip along each row of leads to form proper solder fillets. (E)

8. Return the Mini ThermoJet® to its Tip & Tool Stand.

9. Clean, if required, and inspect.

PACE Intelliheat® Power Supply

TJ-85 Mini ThermoJet®

Flat End Tip (See Chart on Back)

Pik & Paste Liquid Dispensing System


Manual Solder Paste Dispenser

Solder Paste

Paste Dispensing Needles


Product Image Dimensions Part Number